This course is taught by a rotating pool of instructors including the following experts listed in alphabetical order below.
Hugo Julien, P.Eng., began his career, in the field of pressure equipment, pipeline and storage tanks, as Designer and Quality Manager at HC Vidal Ltd. (1998 to 2002) a pressure equipment and boiler manufacturer. He then worked as Quality Systems Manager at Xebec, Inc. (2002 to 2007) another pressure equipment manufacturer. From 2007 to 2019, he has been the Mechanical Integrity Advisor at GCM Consultants, an engineering firm. Since January 2019, he has been working for CEP Forensic as a Forensic Engineer, where he investigates the causes of rupture, leakage, explosion, etc.
An active associated member CSA B51, he is a certified API 510, API 570, API 571, and CSA W178.2 Level II (CSA B31.3, ASME W47.1/W59, and CSA Z662) inspector. Mr. Julien graduated from l'École Polytechnique of Montréal (1997) in Mechanical Engineering.
John P. Swezy, Jr. has over 40 years of experience in steam and combustion driven prime mover electrical generation plants and associated engineering auxiliary systems, He has over 30 years of experience in developing and implementing detailed procedures, work instructions, and QC programs for design, welded fabrication, repairs, and alterations of pressure equipment following ASME, B31, NBIC, API, DOT and various International Codes and Standards. John has extensive practical experience with nondestructive examination and welding technology.
Mr. Swezy has been a member of various ASME Codes & Standards Committees since 1996. He is a National Board Commissioned Boiler and Pressure Vessel Inspector and an American Welding Society Certified Welding Inspector (CWI). He is recognized for his expertise with the ASME Code rules of Section VIII, Divisions 1 and 2 as they apply to toughness, fabrication, and examination of pressure vessels. He is past Chair of the Subgroup on Toughness, past Chair of the Subgroup on Fabrication and Examination, and member of the Standards Committee for Pressure Vessels. John is also a member of the Standards Committee for Welding, Brazing, and Fusing; the ASME B31 Piping Standards Committee; and past Chair of the B31 Fabrication and Examination Technical Committee. John was presented the ASME Dedicated Service Award in 2013 and elected an ASME Fellow in September 2019.